Delta 34-814 Instruction Manual download pdf (Page 14)

Use four #10 x 1/2" sheet metal screws to attach the rip

fence holder brackets (A) and (B) Fig. 33 to the four holes

located in the left hand side of the saw cabinet.

The Unisaw is supplied with a dust chute adapter to

connect a 4" diameter dust collector hose to the

machine. Align the four holes in the adapter (A) Fig. 34

with the four holes in the back of the saw cabinet (B).

Attach the dust chute adapter with four #10 x 1/2" sheet

metal screws.

NOTE: Do not mount the dust chute adapter unless you

use a dust collection system with the saw. Without the

system, a dust chute adapter will restrict the gravity feed

opening for saw dust removal.

You can store the miter gauge and arbor wrenches in the

slots (A) Fig. 32 provided in the motor cover.

2. Place the motor cover (A) in the opening of the

Unisaw (Fig. 31). Place the rear motor cover clips

inside the motor opening and push the front of the

motor cover until all 4 motor cover clips are engaged

with the motor cover opening in the Unisaw.

NOTE: To remove the motor cover, depress both sides

of the cover and pull outward.

MITER GAUGE HOLDER AND WRENCH HOLDER

Fig. 31

Fig. 32

ATTACHING THE RIP FENCE HOLDER BRACKETS

Fig. 33

ATTACHING THE DUST CHUTE ADAPTER

Fig. 34

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 14