Delta 34-814 Instruction Manual download pdf (Page 17)

Insert the miter gauge bar into the miter gauge slot on the table. Attach the washer and lock handle (A) Fig. 43 to the

miter gauge bar.

The miter gauge is equipped with adjustable index stops at 90° and 45° right and left. You can make adjustments to the

index stops by tightening or loosening the three adjusting screws (B) Fig. 48 with the supplied Hex wrench

To rotate the miter gauge, loosen the lock knob (A) Fig. 44 and move the body of the miter gauge (C).

The miter gauge body will stop at 90° and 45° both right

and left. To rotate the miter gauge body past these points,

move the stop link (D) Fig. 44 up and out of the way.

The head of the miter gauge pivots on a special tapered

screw (G) Fig. 45. If the miter gauge head does not pivot

freely, or pivots too freely, adjust it by loosening the set

screw (H) Fig. 45, and turning the screw (G) in or out.

NOTE: Tighten screw (H) after you make the adjustment.

Your miter gauge is equipped with a plate (E) Fig. 45 that

fits into the T-Slot groove in the table. This allows the

miter gauge head to go off the front edge of the table

without falling, allowing for a longer cut off capacity.

Place a straight edge (B) across the table at both ends of

the table insert (Fig. 42). The table insert (A) should

always be level with the table. To adjust, turn the

adjusting screws (C), with a supplied hex wrench.

NOTE: You can store the hex wrenches in the miter

gauge handle when not in use. Remove the top cap

(A) Fig. 44 for storage.

ADJUSTING THE TABLE INSERT

MITER GAUGE OPERATION AND ADJUSTMENT

Fig. 42

Fig. 43

Fig. 44

Fig. 45

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:43 PM Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 17