Delta 34-814 Instruction Manual download pdf (Page 9)

Use a straight edge (C) Fig. 6 to be sure that the

extension wing (A) and the saw table (D) are even with

each other before tightening the screws (B) Fig. 5.

If your saw has magnetic push button electrical controls,

the starter box is already wired to the switch and motor.

However, you will need to mount the starter box to the

saw cabinet.

1. Place a 1/4" lockwasher, then a 1/4" flat washer on

a 1/4-20x1/2" hex head bolt. Insert the bolt through

one of the holes (B) Fig. 7 on the inside of the saw

cabinet and into the matching tapped hole (C) Fig. 7

in the starter.Tighten just enough to hold the starter.

2. Repeat for the remaining 2 holes.

3. Tighten all three bolts securely.

ATTACHING THE LVC STARTER BOX TO THE CABINET

1. Locate the LVC switch (A) Fig. 8 and the hardware that was removed in the section “ATTACHING THE EXTENSION

WING.”

2. Use the hardware to mount the switch bracket (C) Fig. 9 to the inside of the table through the hole (D) on the left

front edge of the extension wing.

NOTE: If you have a GPE switch see “ATTACHING THE GPE ON/OFF Switch” instructions.

ATTACHING THE LVC ON/OFF SWITCH

Fig. 6

Fig. 7

Fig. 8

Fig. 9

422-04-651-0064 - 06-20-05.qxd 6/20/05 1:42 PM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 34-814 Instruction Manual Page 9