Delta 36-L336 Use and Care Manual download pdf (Page 14)

OPERATION

To reduce the risk of personal injury, turn

unit off and disconnect it from power source before

installing and removing accessories, before adjusting

or when making repairs. An accidental start-up can

cause injury.

STARTING AND STOPPING THE SAW

Make sure that the saw has been turned

"OFF" before plugging cord into outlet. Do not touch

the plug’s metal prongs when unplugging or plugging

in the cord.

1. The POWER switch (X) Fig. 19 is located underneath

the front left extension wing. To turn the saw "ON",

push the round button (X) Fig. 19.

2. To turn the saw "OFF", push the button (Y) Fig. 19.

LOCKING SWITCH IN THE "OFF" POSITION

IMPORTANT: When the machine is not in use, the saw

should be turned off and the "ON" button locked out to

prevent unauthorized use. To lock out “ON” button, use a

standard long shackle lock (Z) Fig. 20, with a shackle that

is at least 2-3/4" (70 mm) long and with shackle posts no

larger than 9/32" (7 mm) thick.

In the event of a power outage (such as

a breaker or fuse trip), always move the switch to the

"OFF" position until the main power is restored.

OVERLOAD PROTECTION

Your saw is supplied with overload protection. If the

motor shuts off or fails to start due to overloading (cutting

stock too fast, using a dull blade, using the saw beyond

its capacity, etc.) or low voltage, let the motor cool three

to five minutes. The overload will automatically reset itself

and the machine can then be started again by pressing

the "ON" button.

NOTICE

AVIS

AVISO

If the motor continually shuts off due to

overloading, contact a qualified electrician.

RAISING AND LOWERING THE BLADE

Raise or lower the blade with the left handwheel (AA)

Fig. 21. Before raising or lowering the blade, be sure to

loosen the lock knob (BB) Fig. 21 by turning it counter-

clockwise.

To raise the saw blade, turn the handwheel (AA), clockwise.

To lower the saw blade, turn handwheel (AA) counter-

clockwise.

OPERATIONAL CONTROLS AND ADJUSTMENTS

FIG. 19

FIG. 20

FIG. 21

FIG. 22

Tighten lock knob (BB) Fig. 21 to keep blade raised to your desired height. Only a small amount of force is required to lock

the blade raising mechanism securely. Any added force merely puts unnecessary strain on the locking device.

For most applications, it is recommended that you raise the blade 1/8" (3.2 mm) to 1/4" (6.4 mm) above the top surface of

the workpiece, as shown in Fig. 22. (NOTE: Guard removed for clarity only.)

NOTE: With hollow-ground blades, raise the blade to its maximum height to provide greater clearance.

Lock the blade in position before starting the saw.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 107 108

Comments to this Manuals

No comments

Delta 36-L336 Use and Care Manual Page 14

Comments to this Manuals