Delta 36-L336 Use and Care Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 108
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
22
ADJUSTING BELT TENSION
1. Open the motor cover.
2. Loosen the bolt (H1) Fig. 54A, and carefully let the
motor rest on the belts.
3. Correct belt tension is indicated with a 1/4" (6.4 mm)
deflection in the center span of the pulleys, using light
finger pressure.
4. When proper tension is achieved, tighten bolt (H1)
Fig. 54A.
NOTE: For instructions on replacing the belts see the
Maintenance section.
FIG. 54A
H1
BLADE GUARD OPERATION
To reduce the risk of injury, turn unit off
and disconnect it from power source before installing
and removing accessories, before adjusting or when
making repairs. An accidental start-up can cause injury.
If there is a need to briefly raise the blade guard (for
example, to make a measurement) the guard can be parked
in a raised position. Lift the guard from the front (as shown
in Fig. 54B) and raise guard shield until it snaps into a
locked position above the table. One or both guard shields
can be raised.
When done making the measurement (Figure 54C), return
guard to operating position (Figure 54D).
Keep arms, hands and fingers away from
the blade to prevent serious injury.
To reduce the risk of injury, you must use
the saw blade guard for all through-cuts.
FIG. 54B
FIG. 54C
FIG. 54D
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 107 108

Comments to this Manuals

No comments