Delta 36-L336 Use and Care Manual download pdf (Page 25)

BEVEL RIPPING

Bevel ripping (Fig. 57) is the same as ripping except the

bevel angle is set to an angle other than 0°.

Before connecting the table saw to the

power source or operating the saw, always inspect

the blade guard assembly and riving knife for proper

alignment and clearance with saw blade. Check

alignment after each change of bevel angle.

When possible, place the fence on the

right side of the blade so that the blade is tilted away

from the fence and hands. Keep your hands clear of

the blade and use a pushstick to feed the workpiece if

there is less than 6" (152 mm) between the fence and

the blade.

Use caution when starting the cut to

prevent binding of the guard against the workpiece.

CROSSCUTTING

NEVER touch the free end of the

workpiece or a free piece that is cut off, while

the power is ON and/or the saw blade is rotating.

Piece may contact the blade resulting in a thrown

workpiece and possible injury.

To reduce the risk of injury, NEVER

use the fence as a guide or length stop when

crosscutting.

NEVER use a length stop on the free

end of the workpiece when crosscutting. In short,

the cut-off piece in any through-sawing (cutting

completely through the workpiece) operation must

never be confined — it must be allowed to move

away from saw blade to prevent contact with blade

resulting in a thrown workpiece and possibly injury.

Use caution when starting the cut to

prevent binding of the blade guard assembly against

the workpiece resulting in damage to saw and

possible injury.

When using a block as a cut-off gauge,

the block must be at least 3/4" (19 mm) thick and

is very important that the rear end of the block be

positioned so the workpiece is clear of the block

before it enters the blade to prevent contact with

blade resulting in a thrown workpiece and possibly

injury.

Cross-cutting is cutting the wood across the grain. It

requires the use of the miter gauge to posi tion and guide

the work. Before starting the cut, raise the blade so

that it is about 1/8" (3.2 mm) higher than the top of the

workpiece. Place the work against the miter gauge and

advance both the gauge and work toward the saw blade

(Fig. 58).

FIG. 57

FIG. 58

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 107 108

Comments to this Manuals

No comments

Delta 36-L336 Use and Care Manual Page 25

Comments to this Manuals