Delta 36-L336 Use and Care Manual download pdf (Page 26)

You can use the miter gauge in either table slot. Start

the cut slowly and hold the work firmly against the miter

gauge and the table. Keep both hands on the miter

gauge and workpiece. Do not touch the cut-off piece.

Feed the workpiece steadily through the blade until the

workpiece is completely cut. Shift the workpiece slightly

sideways away from the blade, then pull the workpiece

and miter guage back to the starting position. Remove

the workpiece, then use a push stick to push the cut-off

piece past the blade and off the table before beginning

the next cut.

For added safety and convenience, you can fit the miter

gauge with an auxiliary wood-facing that should be at

least 1" (25 mm) higher than the maximum depth of cut,

and should extend out 12" (305 mm) or more to one

side or the other depending on which miter gauge slot is

being used. This auxiliary wood-facing can be fastened

to the front of the miter gauge by using two wood screws

through the holes (D) Fig. 59 provided in the miter gauge

body and into the wood-facing.

When cross-cutting a number of pieces to the same

length, clamp a block of wood (E) Fig. 60 to the fence

and use it as a cut-off gauge. The block (E) must be

at least 3/4" (19 mm) thick to prevent the cut-off piece

from binding between the blade and the fence during

removal from the saw table. Always position this block of

wood in front of the saw blade. Once the cut-off length

is determined, lock the fence and use the miter gauge to

feed the work into the cut.

BEVEL CROSSCUTTING

Bevel crosscutting (Fig. 61) is the same as crosscutting

except the bevel angle is set to an angle other than 0°.

Before connecting the table saw to the

power source or operating the saw, always inspect

the blade guard assembly and riving knife for proper

alignment and clearance with saw blade. Check

alignment after each change of bevel angle.

When possible, use the right miter gauge

slot when bevel crosscutting so that the blade tilts

away from the miter gauge and your hands.

Use caution when starting the cut to

prevent binding of the guard against the workpiece.

FIG. 59

FIG. 60

FIG. 61

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 107 108

Comments to this Manuals

No comments

Delta 36-L336 Use and Care Manual Page 26

Comments to this Manuals