Delta 36-L336 Use and Care Manual download pdf (Page 32)

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltaportercable.com for a list of service centers or call the

DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and

removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

KEEP MACHINE CLEAN

Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.

NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.

FAILURE TO START

Should your machine fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet.

Also, check for blown fuses or open circuit breakers in the line.

LUBRICATION & RUST PROTECTION

Apply hardwood flooring paste wax to the machine table, extension table or other work surface weekly. Or use a

commercially available protective product designed for this purpose. Follow the manufacturer’s instructions for use and

safety.

To clean cast iron tables of rust, you will need the following materials: a medium sized scouring pad, a can of spray

lubricant and a can of degreaser. Apply the spray lubricant and polish the table surface with the scouring pad. Degrease

the table, then apply the protective product as described above.

MAINTENANCE REMINDERS

Wear certified safety equipment for eye, hearing and respiratory protection while using compressed air.

Here are some regular maintenance items to remember for your Unisaw:

RIVING KNIFE CLAMP PLATE (A) Fig. 80: Keep this area free of dust and debris buildup. Blow out area regularly with

compressed air.

RIVING KNIFE CLAMP POST (B) Fig. 81: Use lubricant on this area - the post of screw (B) - occasionally to ensure free

movement. Place the lubricant on bearing surface of clamp post (B) where it enters the locator block (C) Fig. 80.

NOTE: If the riving knife clamp can't move freely, have the saw serviced by authorized DELTA Machinery service center

personnel.

TRUNNION GREASE FITTINGS: Grease the trunnion at two fittings (one shown at (D) Fig. 82) as needed with a lithium-

based grease.

FIG. 80

FIG. 81

FIG. 82

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 107 108

No comments

Delta 36-L336 Use and Care Manual Page 32