Delta 31-392 User Manual download pdf (Page 3)

ADDITIONAL SAFETY RULES FOR

ABRASIVE FINISHING MACHINES

1. DO NOT OPERATE THIS MACHINE UNTIL it is

assembled and installed according to the instructions.

2. OBTAIN ADVICE from your supervisor, instructor, or

another qualified person if you are not familiar with the

operation of this machine.

3. FOLLOW ALL WIRING CODES and recommended

electrical connections.

4. USE THE GUARDS WHENEVER POSSIBLE. Check

to see that they are in place, secured, and working

correctly.

5. CHECK BELTS for wear and tension. If the belt is

damaged or can’t be tensioned properly, replace it.

6. CHECK FOR CORRECT BELT INSTALLATION, and

insure that the belt is tracking properly.

7. KEEP ARMS, HANDS, AND FINGERS away from

abrasive surfaces.

8. AVOID AWKWARD OPERATIONS AND HAND

POSITIONS where a sudden slip could cause a hand

to contact the sanding surface.

9. NEVER WEAR GLOVES or hold the workpiece with a

rag when sanding.

10. NEVER START THE MACHINE with the workpiece

against the sanding surface.

11. NEVER START THE MACHINE before clearing the

table of all objects (tools, scrap pieces, etc.).

12. MAINTAIN MINIMUM CLEARANCE between the

table and the sanding surface.

13. USE A BACKSTOP when using the belt finishing

machine in a horizontal position.

14. FEED THE WORKPIECE AGAINST THE

ROTATION OF THE SANDING SURFACE. Hold

the workpiece securely on the table.

15. USE A DUST COLLECTION SYSTEM.

16. CLEAN THE MACHINE AND DUST

COLLECTION SYSTEM THOROUGHLY BEFORE

AND AFTER SANDING METAL. Combining wood

dust and metal filings (or aluminum filings and

metal filings) can create a fire hazard. DO NOT

sand magnesium. It is highly flammable.

17. FOR DRUM SANDERS, DO NOT SAND

WORKPIECES SHORTER THAN 7" or thinner

than 1/32".

18. PROPERLY SUPPORT LONG OR WIDE

workpieces.

19. DISCONNECT THE MACHINE from the power

source before installing or removing accessories,

before adjusting or changing set-ups, or when making

repairs.

20. DISCONNECT THE MACHINE from the power

source, and clean the table/work area before leaving

the machine. LOCK THE SWITCH IN THE “OFF”

POSITION to prevent unauthorized use.

21. ADDITIONAL INFORMATION regarding the safe and

proper operation of this machine is available from the

Power Tool Institute, 1300 Summer Avenue,

Cleveland, OH 44115-2851. Information is also

available from the National Safety Council, 1121

Spring Lake Drive, Itasca, IL 60143-3201. Please refer

to the American National Standards Institute ANSI

01.1 Safety Requirements for Woodworking

Machines and the U.S. Department of Labor OSHA

1910.213 Regulations.

WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.

SAVE THESE INSTRUCTIONS.

Refer to them often

and use them to instruct others.

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments

Delta 31-392 User Manual Page 3

Comments to this Manuals

Related products and manuals for Grinding machines Delta 31-392