Delta 31-392 User Manual download pdf (Page 8)

ASSEMBLING AUXILIARY ABRASIVE

DRUM AND SPINDLE ASSEMBLY TO

DRIVE PULLEY

The auxiliary abrasive drum and spindle assembly is

furnished as standard equipment with the edge sander

and is used for finish sanding of small contour

workpieces. To assemble the abrasive drum and spindle

assembly, proceed as follows:

NOTE: The top guard and dust chute assembly has been

removed for clarity.

1. DISCONNECT TOOL FROM POWER SOURCE.

2. Align the three holes (A) Fig. 11, in adapter plate (B)

with three holes in top of drive pulley (C) and fasten

adapter plate (B) Fig. 12, to drive pulley with three 5/16-

18 x 3/4" long flat head screws (D).

3. Three abrasive drum spindles are supplied as stand-

ard equipment with the edge sander. Loosen set screw

(E) Fig. 13, in adapter plate (B), and insert the desired

abrasive drum spindle, one of which is shown at (F), into

the adapter plate (B). NOTE: Make certain flat on spindle

(F) is facing set screw (E).

4. Firmly tighten set screw (E) Fig. 14, to fasten drum

spindle (F) in place.

5. Assemble the proper abrasive sleeve (G) Fig. 15, over

the desired drum spindle (F). NOTE: There are three

abrasive sleeves supplied, with inside diameters of 1-

1/2", 2" and 3" which will fit over the abrasive drum

spindles (F) Fig.16 supplied. IMPORTANT: If the

abrasive sleeve (G) will not slide over the spindle drum

(F) Fig. 15, smoothly, loosen spindle nut (H) until abrasive

sleeve (G) fits on spindle drum (F).

6. Tighten spindle nut (H) Fig. 16, to hold abrasive sleeve

(G) firmly on spindle drum.

Fig. 12

Fig. 13

Fig. 14

Fig. 15

Fig. 16

Fig. 11

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 31-392 User Manual Page 8