Delta 31-392 User Manual download pdf (Page 9)

ASSEMBLING AUXILIARY END TABLE

ASSEMBLY

The auxiliary end table is furnished as standard equip-

ment with the edge sander. The table is used when

performing contour sanding operations around the drive

pulley and auxiliary abrasive drum and spindle assembly.

To assemble the auxiliary end table proceed as follows:

1. DISCONNECT TOOL FROM POWER SOURCE.

2. Align the two holes (A) Fig. 17 in end table support

bracket (B) with two holes (C) in the side of the edge

sander and fasten with two 3/8-16 x 1-1/4" long hex

head screws (D) Fig. 18, flatwashers, lockwashers, and

hex nuts. Assemble flatwashers on bolts. Insert bolts

through holes. Assemble lockwashers and hex nuts and

tighten securely.NOTE: The top guard and dust chute

assembly has been removed for clarity.

3. Turn the auxiliary end table (D) Fig. 19, face down on

a supporting surface and slide table support column

assembly (E) into channels of plate (F) on the underside

of table (D) as shown.

4. Tighten lock screw (G) Fig. 20, to fasten table (D) to

table support column assembly (E). NOTE: Adjustments

to table can be made later.

5. Insert end table assembly (H) Fig. 21, into bracket (B)

which was assembled in STEP 2. Tighten lock knob (J)

Fig. 22, to hold end table assembly (H) in position in

bracket (B).

6. Reassemble top guard and dust chute assembly to

machine.

7. Refer to section "Adjusting Auxiliary End Table" for

proper end table positions and adjustments.

Fig. 17

Fig. 18

Fig. 19

Fig. 20

Fig. 21

Fig. 22

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 31-392 User Manual Page 9