Delta 31-552 User Manual Page 1

INSTRUCTION MANUAL6" Abrasive BeltFinishing Machine(Model 31-552)PART NO. 406-03-651-0017 (0110)Copyright © 2001 Delta MachineryTo learn more abo

10INSTALLING OR REMOVINGABRASIVE BELTYour machine uses a 6"x48" belt. To install or remove thebelt, proceed as follows:DISCONNECT MACHINE FR

11ABRASIVE BELTS - THEIR SELECTION AND USEDelta supplies a wide range of belts for use on your Finishing Machine. These belts are recommended for a wi

The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): BAMMER®,INNOVATION THAT WORKS®, JETST

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

ADDITIONAL SAFETY RULES FORABRASIVE BELT FINISHING MACHINES3WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURYSAVE THESE INS

4POWER CONNECTIONSIMPORTANT: Make sure the electrical characteristics are the same between the motor nameplate and the powersource and make sure the

5Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug

6ASSEMBLYSTAND AND ELECTRICALSIf you purchased your machine with the optional steelstand and electricals, the stand is shipped as shown inFig. 2. The

7ALIGNING PULLEYS,ASSEMBLING BELT ANDADJUSTING BELT TENSIONDISCONNECT MACHINE FROM POWER SOURCEUsing a straight edge (A) Fig. 6, make certain the moto

8OPERATING CONTROLS AND ADJUSTMENTSSTARTING AND STOPPINGTHE ABRASIVE FINISHINGMACHINETo start the machine, push “ON” button (A) Fig. 10. Tostop the ma

9ADJUSTING TABLEDISCONNECT MACHINE FROM POWER SOURCE.To tilt the table, loosen the table tilting handle (A) Fig. 15,move the table to the desired angl