Delta (Model 31-695) User Manual download pdf (Page 11)

Fig. 17

LOCKING SWITCH IN THE “OFF” POSITION

When the machine is not in use, the switch should be locked in the “OFF” position to prevent

unauthorized use.

This can be done by grasping the switch toggle (B) and pulling it out of the switch, as shown in Fig. 20. With the switch

toggle (B) removed, the switch will not operate. However, should the switch toggle be removed while the sander is

running, it can be turned “OFF” once, but cannot be restarted without inserting the switch toggle (B).

Fig. 18

TRACKING THE SANDING BELT

1. Turn the switch “ON” and “OFF” to see if the sanding belt tracks correctly. If the belt does not move to one side

or the other and rides on the center of the sanding drums, the belt is tracking properly.

2. If the sanding belt moves toward the disc, turn the tracking knob (A) Fig. 18 counterclockwise 1/4 turn.

3. If the sanding belt moves away from the disc, turn the tracking knob (A) Fig. 18 clockwise 1/4 turn.

4. Turn the switch “ON” and “OFF” again to check the tracking. Adjust again, if necessary.

CHANGING POSITION OF SANDING ARM

The sanding arm (A) Fig. 19 can be used in the horizontal position (Fig. 19), or in the vertical position (Fig. 20), or any

angle in between. To change the position, loosen the screw (B) Fig. 20 with the hex wrench (C), move the arm (A) Fig.

20, to the desired location and tighten the screw (B).

Fig. 19

Fig. 20

ADJUSTING SANDING ARM STOP

A positive stop is provided to position the sanding arm level with the workbench when the arm is in the horizontal

position.

1. Place the sanding arm in the horizontal position.

DISCONNECT MACHINE FROM POWER SOURCE.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

No comments

Delta (Model 31-695) User Manual Page 11