Delta (Model 31-695) User Manual download pdf (Page 14)

Fig. 30

Fig. 31

USING TABLE ASSEMBLY WITH

SANDING BELT

Use the table assembly with the

sanding belt in the vertical position ONLY.

To move the table assembly (B) Fig. 30 to the sanding

arm (A):

1. Remove the backstop (C) Fig. 30.

2. Loosen the screw (D) Fig. 30 and carefully remove

support bar (E) and table assembly (B) from the disc

unit.

3. Loosen the set screw (F) Fig. 31. insert the support

bar (E) (with the table assembly (B) attached) in the

hole (G) Figs. 30 & 31. Tighten the set screw (F).

The table edge must be positioned

a maximum of 1/16" away from the

sanding belt to avoid trapping the

workpiece or fingers between the

table and the sanding belt.

Fig. 32

DUST SPOUT

A dust spout (A) Fig. 32 is supplied with your sander and

can easily be connected to a standard shop vacuum

hose. The inside diameter opening of the dust spout (A)

is 2-1/4".

Fig. 33

ADJUSTING DUST SHIELD

This sander is equipped with a manually operated dust

shield (A) Fig. 33 for use with a dust collection system.

You must adjust the shield to suit your sanding

operation.

1. If you are sanding with the disc, push in on the dust

shield (A) Fig. 33.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Delta (Model 31-695) User Manual Page 14