Delta (Model 31-695) User Manual download pdf (Page 16)

Fig. 39

Fig. 40

5. Place a new 6" x 48" sanding belt (F) Fig. 40 over

both sanding drums (G). Ensure that the belt will

travel in the direction of the arrows printed on the

inside of the belt.

6. Move the tension lever (E) Fig. 39 left to the

“TIGHTEN” position.

7. Replace the support bracket, backstop and upper

sanding drum guard, removed in STEPS 1 and 2.

8. Connect the electrical power to the sander. If the belt

is not tracking properly, refer to section “TRACKING

THE SANDING BELT.”

4. Move the tension lever (E) Fig. 39, to the right to the

“LOOSEN” position (F). Remove the sanding belt (F)

from both sanding drums.

REPLACING SANDING DISC

Fig. 41

1. Loosen the screw (A) Fig. 41, and remove the table

assembly (B).

2. Remove the three screws (C) Fig. 42 and lower the

cover (D).

3. Peel off the old disc (E) Fig. 43.

4. Make sure the disc plate (F) Fig. 43 is clean. Peel the

backing from a new sanding disc. Press the new

sanding disc firmly into position on the disc plate (F).

Replace the lower cover and table assembly,

removed in STEPS 1 and 2.

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 42

Fig. 43

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

No comments

Delta (Model 31-695) User Manual Page 16