Delta (Model 31-695) User Manual download pdf (Page 17)

Fig. 45Fig. 44

SURFACING OR EDGE SANDING WITH SANDING BELT

When surfacing (Fig. 44) or edge sanding (Fig. 45), place the sanding arm in the horizontal position and use the

backstop (A) Fig. 44 and Fig. 45 to keep the workpiece in place. Hold the workpiece firmly and keep your fingers away

from the sanding belt. Place the end of the workpiece against the backstop and move the workpiece evenly across the

sanding belt. Apply only enough pressure to allow the sanding belt to remove material. Use extra caution when sanding

very thin pieces.

Position the edge of the backstop a maximum of 1/16" away from the sanding belt to avoid

trapping the workpiece or your fingers between the backstop and the sanding belt.

OPERATING CONTROLS AND ADJUSTMENTS

Fig. 46

SANDING INSIDE CURVES

You can sand inside curves on the top sanding drum

(Fig. 46).

Replace the sanding drum guard after

the sanding operation is completed.

Fig. 47

SANDING OUTSIDE CURVES

Sand outside curves on the sanding disc as illustrated in

Fig. 47.

Always sand on the left (downward)

side of the sanding disc. Sanding on

the right (upward) side of the sanding

disc could cause the workpiece to fly

up, which could be hazardous.

The edge of the table must be

positioned a maximum of 1/16" away

from the sanding disc to avoid

trapping the workpiece or fingers

between the table and sanding disc.

1 2 ... 12 13 14 15 16 17 18 19 20 21

No comments

Delta (Model 31-695) User Manual Page 17