Delta (Model 31-695) User Manual download pdf (Page 9)

BELT AND PULLEY GUARD

Place an M6.4 lockwasher and an M6.4 flat washer in

that order on two M6 x 55mm hex socket head screws

(B), and attach the belt and pulley guard (A) Fig. 8 to the

machine. NOTE: Install the plug (C) in the guard.

SANDING DISC PLATE

1. Place the key (C) Fig. 9 into the keyway of the

driveshaft and slide the sanding disc plate (A) Fig. 9

on the drive shaft until it is flush with the end of the

drive shaft (Fig. 10).

Do not allow the drive shaft (B) to extend past

the plate surface.

2. Insert a hex wrench (E) Fig. 11 through the slot (F) in

the back of belt and pulley guard (G). Tighten the set

screw that holds the disc plate on the drive shaft.

Fig. 8

Fig. 9

NOTE:

Fig. 11

Fig. 10

Fig. 12

SANDING DISC TO DISC PLATE

1. Clean the sanding disc plate (A) Fig. 12.

2. Peel the backing from the sanding disc (B) Fig. 12.

Press the disc firmly into position on the sanding

disc plate (A).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

No comments

Delta (Model 31-695) User Manual Page 9