Delta ShopMaster SM500 User Manual download pdf (Page 13)

3. Alternately, you can secure the sander by fastening it

to a mounting board 18" x 24" or larger. The diagram

in Fig. 16 shows the size and center-to-center

distance of the holes that you will need to drill in the

mounting board.

N O T E : For proper stability, countersink the holes

underneath the mounting board so that the screw heads

are flush with bottom surface.

4. Securely clamp the mounting board to a stand or

workbench using 2 or more “‘C” clamps, as shown in

Fig. 17.

Secure the machine base to the supporting

surface. If there is any tendency for the stand or workbench

to move during operation, the stand or workbench must be

fastened to the floor.

1. The on/off switch (A) Fig. 18 is located on the front

of the sander. To turn the machine “ON”, move

the switch up to the “ON” position.

2. To turn the machine “OFF”, move the switch (A)

down to the “OFF” position.

O P E R AT I O N

O P E R AT I O N A L CONTROLS AND ADJUSTMENTS

Make sure that the switch is in the “OFF” position before plugging in the power cord. In the event of

a power failure, move the switch to the “OFF” position. An accidental start-up can cause injury.

STARTING AND STOPPING THE SANDER

Fig. 16

Fig. 17

Fig. 18

l l

18 MIN

5-1/2"

15-1/2"

24 MIN

3/8" DIAMETER

(4) HOLES

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 67 68

No comments

Delta ShopMaster SM500 User Manual Page 13