Delta ShopMaster SM500 User Manual download pdf (Page 16)

2. To adjust, loosen the three screws (B) Fig. 29 that

fasten the table to the table mounting bracket and

trunnion. Adjust the table accordingly - then tighten

the three screws (B).

MITER GAUGE

Use the miter gauge (A) Fig. 30 on the disc table. You can

rotate the miter gauge body right or left for angle or miter

sanding by loosening the lock knob (B), rotating the miter

gauge body, and tightening the lock knob.

1. Place an adjustable combination square on the table with the part (A) Fig. 27 in the miter gauge slot (B) to check

the distance from the slot to the sanding disc. Check the other side of the disc in the same manner (Fig. 28). The

distances should be the same.

ADJUSTING THE MITER GAUGE SLOT PARALLEL WITH THE SANDING DISC

DISCONNECT MACHINE FROM POWER SOURCE.

Fig. 27

Fig. 28

Fig. 29

Fig. 30

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

No comments

Delta ShopMaster SM500 User Manual Page 16