Delta ShopMaster SM500 User Manual download pdf (Page 19)

M A C H I N E U S E

SURFACING OR EDGE SANDING WITH THE SANDING BELT

Always use the backstop (A) Figs. 39 and 40 when surface-sanding (Fig. 39) or when edge sanding Fig. 40. Hold the

workpiece firmly and keep your fingers away from the sanding belt. Keep the end of the workpiece against the backstop

and move the workpiece evenly across the sanding belt. Apply only enough pressure to allow the sanding belt to remove

material. Use extra caution when sanding very thin pieces.

Fig. 39

Fig. 40

To avoid trapping the work or fingers between the backstop and the sanding belt, the edge of the

table should be positioned a maximum of 1/16" away from the sanding belt .

Sanding inside curves with the sanding belt is illustrated in Fig. 41.

Sanding outside curves with the sanding disc is illustrated in Fig. 42.

SANDING INSIDE AND OUTSIDE CURVES

Fig. 42

Fig. 41

Always sand on the left (downward) side of the sanding disc (Fig. 41). Sanding on the right

(upward) side of the sanding disc could cause the workpiece to fly up suddenly which could be

hazardous.

To avoid trapping the work or fingers between the backstop and the abrasive, the edge of the

table should be positioned a maximum of 1/16" away from the abrasive .

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 67 68

No comments

Delta ShopMaster SM500 User Manual Page 19