Delta A09733 Instruction Manual download pdf (Page 11)

11- ENG

A09733

HOW TO APPLY CHEMICALS

AND CLEANING SOLVENTS

Applying chemicals or cleaning

solvents is a low pressure operation.

NOTE: Use only soaps and chemicals

designed for pressure washer use.

Do

not use bleach.

To Apply chemicals:

1. Press chemical

hose onto

barbed ﬁtting

located near high

pressure hose

connection of

pump as shown.

2. Place other end

of chemical

hose with ﬁlter on it into container

holding chemical/cleaning

solution. NOTE: For every 7

gallons of water pumped 1 gallon

of chemical/cleaning solution will

be used.

3. Install low pressure (black)

nozzle into quick connect ﬁtting

of spray wand, see How To Use

Spray Wand paragraph in this

section.

4. After use of chemicals,

place

chemical hose into container

of clean water and draw

clean water through chemical

injection system to rinse

system thoroughly. If chemicals

remain in the pump it could be

damaged. Pumps damaged due

to chemicals will not be covered

under warranty.

NOTE: Chemicals and soaps will not

siphon when spray wand is in the high

pressure setting.

CHANGING NOZZLES ON SPRAY

WAND

Risk of Flying

Object could

cause risk of serious injury. DO

NOT attempt to change nozzles

while pressure washer is running.

Turn engine off before changing

nozzles.

1. Pull quick

connect coupler

back and insert

nozzle.

2. Release quick

connect coupler

and twist nozzle to make sure it

is secure in coupler.

Risk of Flying

Object could

cause risk of serious injury. Ensure

nozzle is completely inserted in

QC socket, and QC snap ring is

fully engaged (forward) before

squeezing gun trigger.

Risk of injection or

injury to person.

Do not direct discharge stream

toward persons, unprotected

skin, eyes, or any pets or animals.

Serious injury can occur.

Barb

Fitting

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments