Delta A09733 Instruction Manual download pdf (Page 12)

12- ENG

A09733

STARTING

Prior to starting, refer to your

engine manual for proper starting

procedure.

1. In a well ventilated outdoor area

add fresh, high quality, unleaded

gasoline with a pump octane

rating of 86 or higher. Do not

overﬁll. Wipe up spilled fuel before

starting the engine. Refer to

Engine Owners Manual for correct

procedure.

2. Check engine oil level.

See

Engine Owners Manual for correct

procedure. NOTE: There will

be a slight amount of oil in the

engine from factory testing.

3. Verify

the ﬁlter

screen

is in

water inlet

of pump.

NOTE:

Cone side

faces out.

4. Connect

water source to pump inlet.

NOTE: Water source must provide

a minimum of 5 gallons per minute

at 20 PSI.

5. Connect high pressure hose to

pump outlet.

6. If applying a chemical or

cleaning solution, see How

To Apply Chemicals/Cleaning

Solvents instructions in this

section.

7. Turn water source on.

NOTE: Failure to do so could

cause damage to the pump.

8. Start engine.

See Engine

Owners Manual for correct

procedure.

NOTE: When engine

rope is pulled, pressure starts

building in the gun. If the engine

does not start after two pulls,

pull the gun trigger to relieve this

pressure.

9. Depress trigger on gun to

start water ﬂow.

NOTE: Stand

on a stable surface and grip

gun/spray wand ﬁrmly with both

hands. Expect the gun to kick

when triggered.

NOTE: If using

the "Water

Vroom" surface

cleaning guide,

quickly and

effortlessly guide

it across the flat

surface being

cleaned.

10. Release trigger to stop water

ﬂow.

11. Adjust spray for the task

being

performed by changing quick

connect nozzle. See How To Use

Spray Wand instructions in this

section.

SHUTTING DOWN

1. After each use, if you have

applied chemicals, place chemical

hose into container of clean water

and draw clean water through

chemical injection system to rinse

system thoroughly.

NOTE: Failure

to do so could cause damage to

the pump.

2. Turn engine off.

See Engine

Owner’s Manual.

NOTE: NEVER

turn the water off with the engine

running.

3. Turn water source off.

4. Pull trigger on spray gun to

relieve any water pressure in

hose or spray gun.

5. See Storage section in this manual

for proper storage procedures.

Water

Source

High

Pressure

Hose

Filter Screen

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments