Delta D2300B Instruction Manual download pdf (Page 18)

18- ENG

D28600

TROUBLE SHOOTING GUIDE

PROBLEM

Engine will not

start (see Engine

Manual for

further engine

troubleshooting)

No or low

pressure

(initial use)

CAUSE

CORRECTION

No fuel.

Add Fuel.

Pressure builds up after two pulls

on the recoil starter or after initial

use.

Squeeze gun trigger to relieve

pressure.

Spark plug wire not attached.

Attach spark plug wire.

Choke lever in the “Choke”

position on a “hot” engine or an

engine that has been exposed to

thermal heat for a long period of

time.

Move choke to the “No Choke”

position.

Wand not in high pressure.

See How to Use Wand paragraph

in the Operation Section.

Low water supply.

Water supply must be at least 5

GPM @ 20 PSI.

Leak at high pressure hose.

Nozzle obstructed.

Clean nozzle with paper clip or

nozzle cleaning tool, pour water

into nozzle end to flush out

obstruction.

Water filter screen clogged.

Remove and clean filter.

Defective E-Z start valve.

Check with Authorized Warranty

Service Center (AWSC.)

Air in hose.

Turn off the engine, then the

water source. Disconnect the

water source from the pump inlet

and turn the water source on to

remove all air from the hose.

When there is a steady stream of

water present, turn water source

off. Re-connect water source to

pump inlet and turn on water

source. Squeeze trigger to

remove remaining air

Choke lever in the “Choke” position.

Move choke to the “No Choke”

position.

Throttle control lever is not in the

“Fast” position.

Move throttle control lever to the

“Fast” position.

High pressure hose is too long.

Use high pressure hose under

100 feet.

Choke lever in the “No Choke”

position.

Move choke to the “Choke”

position.

Repair leak. Apply sealant tape

if necessary.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Comments to this Manuals

No comments