Delta 22-785 Instruction Manual download pdf (Page 10)

ASSEMBLING TOP COVER AND

DUST CHUTE

1. Fasten the top cover and dust chute (A) Fig. 16, to

the top of the planer, as shown, using the three

M6x16mm screws (B) supplied. IMPORTANT: The dust

chute opening (C) must point to the rear as shown.

Fig. 16

Fig. 17

2. Fasten the left corner of the cover to the top of the

planer using the remaining M6x16mm screw (D) Fig. 17,

and cord clamp (E). NOTE: The motor cord (F) must be

inserted and positioned into the cord clamp as shown.

OPERATING CONTROLS AND ADJUSTMENTS

Fig. 18

Fig. 19

STARTING AND STOPPING PLANER

1. The on/off switch is located on the front of the

planer. To turn the machine “ON”, push the START

button (A) Fig. 18.

2. To turn the machine “OFF”, push the STOP button

(B) Fig. 18.

MAKE SURE THAT THE SWITCH IS IN

THE “OFF” POSITION BEFORE

PLUGGING IN THE POWER CORD. IN THE EVENT OF A

POWER FAILURE, MOVE THE SWITCH TO THE “OFF”

POSITION. AN ACCIDENTAL START-UP CAN CAUSE

INJURY.

LOCKING SWITCH IN THE “OFF”

POSITION

IMPORTANT: When the machine is not in use, the

switch should be locked in the “OFF” position to prevent

unauthorized use,

using a padlock (C) Fig. 19 with a 3/16"

diameter shackle.

OPERATIONAL CONTROLS AND ADJUSTMENTS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

No comments

Delta 22-785 Instruction Manual Page 10