Delta 22-785 Instruction Manual download pdf (Page 9)

CUTTINGHEAD RAISING AND

LOWERING HANDWHEEL

1. Insert key (A) Fig. 7, into keyway (B) of raising and

lowering shaft.

Fig. 7

Fig. 8

2. Assemble handwheel (C) Fig. 8, to raising and lower-

ing shaft as shown. Make sure key, which was

assembled to shaft in STEP 1, is engaged with keyway

in hub of handwheel (C).

3. Assemble decal (D) Fig. 8, to raising and lowering

shaft as shown.

4. Fasten handwheel (C) Fig. 8, to raising and lowering

shaft using an M10 flat washer (E) and an M10 hex nut

(F) supplied.

5. Assemble handle (G) Fig. 8, to handwheel (C) as

shown.

LIFTING THE MACHINE

1. IMPORTANT: CARE MUST BE TAKEN WHEN

LIFTING THE MACHINE ONTO A STAND OR

WORKBENCH. THE PLANER IS VERY HEAVY AND A

MINIMUM OF FOUR PEOPLE WILL BE REQUIRED

TO LIFT THE MACHINE AS FOLLOWS:

2. Raise the cuttinghead (A) Fig. 10, by turning the

raising and lowering handwheel (B) clockwise, and insert

two 6 or 8 foot long 2 x 4’s (C) between the cuttinghead

and table as shown. Lower the cuttinghead just until it

touches the 2 x 4 ‘s (C) Fig. 10, so that they are

positioned solidly between the table and cuttinghead.

Then with two people on each end of the 2 x 4’s, move

the machine to its desired location.

Fig. 10

6. Loosen two head locking knobs, one of which is

shown at (G) Fig. 9, and turn handwheel assembly (H)

clockwise to raise head assembly. Remove the protective

shipping block (J).

Fig. 9

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Delta 22-785 Instruction Manual Page 9