Delta 46-460 Instruction Manual download pdf (Page 15)

Fig. 28

TROUBLESHOOTING

www.deltaportercable.com



MAINTENANCE

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and removing

accessories, before adjusting or when making repairs. 

KEEP MACHINE CLEAN

     

 

To reduce the risk of injury, wear certified safety equipment for eye, hearing and respiratory protection

while using compressed air.

FAILURE TO START

  



LUBRICATION & RUST PROTECTION











TURNING IN REVERSE (46-460 ONLY)

FOR THE DELTA MODEL 46-460 MIDI-

LATHE ONLY: To reduce the risk of injury, be sure

to only use accessories equipped with locking set

screws for turning the lathe in reverse. Also, do not

switch lathe turning directions until the workpiece

comes to a complete stop.

Care should be taken not to stall the

workpiece when turning in reverse. If a stall should

occur, stop the lathe and verify that the chuck or

faceplate is fully seated and both set screws are

tight before continuing.

       

      







 



         



rotation.

NOTE:     

       

  



        



    



1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

Comments to this Manuals

No comments

Delta 46-460 Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Lathes Delta 46-460