Delta 46-715 Instruction Manual download pdf (Page 10)

ADJUSTING CLAMP ON TOOL REST

To adjust the tool rest clamping action, use a 15/16" wrench to adjust the nut (A) Fig. 16 in the same manner as the headstock and

tailstock.

ATTACHING ON/OFF SWITCH TO TOOL

The "ON/OFF" switch comes unattached to the tool to protect it from damage in shipping. To attach the "ON/OFF" Switch:

1. Remove the two hex bolts (A) Fig. 19 that are attached to the back of the headstock, located near the top.

2. Align the two holes in the bottom of the "ON/OFF" switch with the two holes where the hex bolts were removed in STEP 1.

3. Secure the "ON/OFF" switch to the headstock with the bolts that were removed in STEP 1 (Fig. 20).

STARTING AND STOPPING THE TOOL

The power switch (A) Fig. 22, located under the safety cover (B) Fig. 21, provides electrical power to the adjustable speed drive.

Lift the safety cover (B) and move the switch up to the “ON” position. To turn the power off, push the safety cover (B) down.

NOTE: In case of emergency, immediately push the safety cover (B) down to shut off power.

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should be locked in the “OFF” position to prevent unauthorized use, using a

padlock (C) Fig. 22, with a 3/16" diameter shackle inserted through the holes in the switch plate (D) Fig. 22B.

Fig. 17

Fig. 18

Fig. 19

Fig. 20

Fig. 21

Fig. 22

OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

Fig. 22B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Delta 46-715 Instruction Manual Page 10