Delta 46-715 Instruction Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
19
8. Fig. 69 illustrates the rough cutting of the inside of a bowl.
9. Outboard turning is illustrated in Fig. 70. Note that the headstock (A) is turned 45 degrees and the tool rest auxiliary extension
(B) is attached. Outboard turning generally is used for larger workpieces, but smaller work can be accomplished using this
technique.
MAINTENANCE
B
A
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call
the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).
Fig. 69
Fig. 70
KEEP MACHINE CLEAN
Periodically blow out all air passages with dry compressed
air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while
using compressed air.
FAILURE TO START
Should your machine fail to start, check to make sure the
prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers
in the line.
LUBRICATION
Apply household floor paste wax to the machine table and
extension table or other work surface weekly.
PROTECTING CAST IRON FROM RUST
To clean and protect cast iron tables from rust, you will
need the following materials: 1 pushblock from a jointer,
1 sheet of medium Scotch-Brite™ Blending Hand Pad, 1
can of WD-40
®
, 1 can of degreaser, 1 can of TopCote
®
Aerosol. Apply the WD-40 and polish the table surface
with the Scotch-Brite pad using the pushblock as a
holddown. Degrease the table, then apply the TopCote
®
accordingly.
REPLACING DRIVE BELT
1. Remove the four screws (A) Fig. 71 (three of which are
shown) to take the back off of the headstock.
A
Fig. 71
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments