Delta 46-715 Owner's Manual download pdf (Page 9)

some glue is squeezed out from between the rings. Use a

damp cloth to remove any excess glue. Then loosen the

clamp, check to see that the rings are still aligned as you

wish, and tighten the clamp firmly.

See "RECOMMENDED ACCESSORIES (Options)" for

information on ordering a GLUE/CLAMPING FIXTURE.

FIGURE 9

FINISHING YOUR PROJECT

Once your project has been glued, and dried overnight,

you may return your project back to the

DELTA Lathe for

sanding, detailing and finishing. Simply fit the 1/2" hole in

the bottom of your project back on the arbor and tighten

1/2" nut.

Your STEADY REST and LATHE KNIVES can be

used in the usual way for detailing. However, only sand

paper will yield a nice finish. Use you choice of finish, for

a fine project.

Remember, by using the RING MASTER®, you can

easily duplicate any project.

HAVE FUN!

RECOMMENDED ACCESSORIES (Options) CATALOG NUMBERS

1. Replacement Cutter Blade (Double End) ............................................. 70140

2. Replacement Cutter Set (Double End - High Speed) ............................ 70141

3. 1/2" Diameter Drill With 1/4" Shaft ..................................................... 70130

4. Glue/Clamping Fixture ..........................................................…........... 70100

5. 1/2" Plug Cutter .........................................…......................….......…. 70160

6. Cutter Pre-Set Gauge .............................................................….......... 70138

7. Drum Sander 2 1/2" x 3" ........................................................….......... 70166

1 2 3 4 5 6 7 8 9 10 11 12 13

No comments

Delta 46-715 Owner's Manual Page 9