Delta 46-745 Instruction Manual download pdf (Page 9)

Fig. 10

ATTACHING LEG INSERTS

The lathe is supplied with four leg inserts, one of which

is shown (A) Fig. 10.

To attach the leg inserts to the pedestals, place one side

in the hole provided and gently tap the other side, top,

and bottom with a rubber mallet (B) Fig. 10.

If additional stability is desired, insert 4 x 4 lumber (A) Fig

11 into feet of pedestal (B) Fig. 11. Secure the lumber to

the pedestal with four 3/8-16 bolts (not supplied) in

holes (C) Fig. 11 (two of which are shown).

Fasten the 4 x 4’s to the floor.

HEADSTOCK SPUR CENTER

The spur center (A) Fig.12 is equipped with a No. 2

Morse Taper shank. Inserted this shank into the head-

stock spindle (B). NOTE: Before inserting the spur cen-

ter (A), clean both the shank of the spur center and the

inside of the headstock spindle to remove any grease or

debris. To remove the tapered shank spur center (A) Fig.

13, from the headstock spindle (B) Fig. 13, use the

knockout bar (C) Fig. 13 (supplied) through the hole (D)

in the opposite end of the spindle.

IMPORTANT: NEVER DRIVE THE WORKPIECE INTO

THE SPUR CENTER WHEN IT IS MOUNTED IN THE

HEADSTOCK.

See instructions on setting the spur center into the

workpiece in the “OPERATION“ section of this manual

under “CENTERING THE WORK.”

Fig. 12

Fig. 13

Fig. 11

Attach the Headstock (D) Fig. 11, Tool Rest (E) Fig. 11,

and Tailstock (F) Fig. 11 to the lathe bed (G) Fig. 11.

Notice the tool and centers storage areas located at (H)

Fig. 11, and brackets on the pedestals to accept a 2 x

12” shelf (not supplied) (I) Fig. 11.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Delta 46-745 Instruction Manual Page 9