Delta 4000 Instruction Manual download pdf (Page 66)

81331 Rev 01 Nov 2010

Apparatus nameplate information (serial number, ratings, etc.) may be

documented to identify the asset being tested, and general information regarding

the test conditions (test date, weather conditions, etc.) should also be noted.

Liberal use of the COMMENTS field at the bottom of the form is

recommended for documenting this information.

Description of Tests

Once the equipment to be tested has been properly connected to the HV lead,

LV measuring leads and ground, the desired test mode must be selected before

proceeding. The field "INSULATION TESTED" you enter information what

to be tested, TEST MODE set the test mode, SUPPRESS set Suppression

on/off (D2000/D3000) or if method select method Line Sync (Line Sync

Polarity Reversal) or Freq. Var. (Frequency Variation) method should be used in

Delta 4000

Measurements may be executed from the Multiple Quick Test sub-form or from

Delta Control (Delta Control, only Delta 4000). If Delta Control is opened from

the Delta Control button in PowerDB form, Delta Control will send all data to

be stored in the Multiple Quick Test Sub-form.

Once the desired test mode is chosen, the test sequence is initiated by;

 Right-click on the desired blue highlighted test number

 or press F2 when the actual test row is activated (highlighted in yellow)

 or for Delta4310 press the “Start” button when actual test row is

activated

and click “Start” or “enter” on the pop-up screen to start generating the test

voltage.

The test set will perform the selected test and place the results into the proper

fields for that test line. As additional tests are desired and setup, the test table

will grow to accommodate them.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 107 108

No comments

Delta 4000 Instruction Manual Page 66