Delta 36-255 Instruction Manual download pdf (Page 12)

ADJUSTING CHIP DEFLECTOR

1. DISCONNECT THE SAW FROM THE POWER SOURCE.

2. A chip deflector (A) Fig. 22, is supplied to help prevent

scrap or cut-off pieces from entering the upper blade guard.

The chip deflector (A) should be adjusted so that it is almost

touching the side of the blade by loosening screw (B),

adjusting chip deflector (A) and tightening screw (B).

ADJUSTING 0 AND 45 DEGREE BEVEL

POSITIVE STOPS

1. DISCONNECT THE SAW FROM THE POWER SOURCE.

2. Adjust saw so that both bevel and miter pointers are set at 0 degrees. Tighten bevel lock handle and lock

cuttinghead in down position.

3. Place one end of a square (A) Fig. 23 on the table and the

other end against the blade. The blade should be set at 90

degrees to the table.

4. If an adjustment is necessary, loosen bevel lock handle (H)

Fig. 24. Loosen locknut (B) and turn adjusting screw (C), with

wrenches provided, until blade is 90 degrees to the table.

Tighten locknut (B) and bevel lock handle (H).

5. When the blade is 90 degrees to the table, adjust the pointer

to line up with the 0 degree mark on the bevel scale.

6. Loosen bevel lock handle (H) Fig. 24, and move cuttinghead

all the way to the left bevel position and tighten bevel lock

handle.

7. Use a square (A) Fig. 25, to see if the blade is at 45

degrees to the table.

8. If an adjustment is necessary, loosen the bevel lock

handle. Loosen the locknut (E) Fig. 26, and turn the

adjusting screw (F), with wrenches provided, until the blade

is 45 degrees to the table. Tighten locknut (E) and bevel

lock handle.

9. These positive stops enable the operator to rapidly

position the blade at the most common bevel angles to the

table, 90 and 45 degrees.

Fig. 24

Fig. 25

Fig. 26

Fig. 22

Fig. 23

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

No comments

Delta 36-255 Instruction Manual Page 12