Delta 36-255 Instruction Manual download pdf (Page 6)

MOVING TABLE TO THE 0 DEGREE CUT-OFF POSITION

1. Rotate locking knob (A) Fig. 6 counter-clockwise as far as it will go. Depress lever (B) and rotate table (C) to

the 0 degree straight cut-off position, release lever (B), and tighten locking knob (A).

2. Fig. 7 illustrates the table (C) in the 0 degree straight cut-off position.

3. For proper operation and adjustment of the table, refer to sections, “ROTATING TABLE FOR MITER

CUTTING”, “ADJUSTING CLAMPING ACTION OF TABLE LOCKING MECHANISM” and “ADJUSTING

SLIDING FIT BETWEEN MOVABLE TABLE AND BASE.”

ATTACHING EXTENSION TABLE AND FENCE SLIDE

1. Attach flat washers to the two 3/4” screw assemblies (A) Fig. 7A, and thread into the threaded holes on left

side of the saw.

NOTE: Turn the screws only a few threads into the holes at this time.

2. Attach the table extension (B) Figs. 7A and 7B, to left side of saw table, making sure groove of table

extension (B) is inside flat washers (C) as shown in Fig. 7B.

3. Use a straight edge (C) Fig. 7C, to make the extension table (B) even with saw table (D), and tighten the two

screws (A) Fig. 7B.

Fig. 6

Fig. 7

Fig. 7A

Fig. 7B

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

No comments

Delta 36-255 Instruction Manual Page 6