Delta 36-255L Instruction Manual download pdf (Page 10)

4. Attach the fence slide support (E) Fig. 7D, to the

extension table (B) by using the two 5/16-18 x1 1/4”

long hex head screws, 5/16” lockwashers and 5/16”

flat washers (F). Place lockwasher, then flat washer

on screw and bring screws up through the two holes

(G) in table extension and thread them into the two

threaded holes (H) on bottom of fence slide support.

NOTE: Do not completely tighten screws at this time.

5. Use a straight edge (C) Fig. 7E, to align the fence

slide support (E) with saw fence (J), and tighten the

two screws.

6. Position the fence slide (K) Fig. 7F, in position on top

of saw fence (J) and fence slide support (E). Slide

fence slide (K) back and forth several times to check

alignment of fence slide support (E). Make any

necessary final adjustments to fence slide support.

7. Remove screw and spring (L) Fig. 7G, and lock

handle (M) from locking stud (N).

8. Place 1/4" flat washer (O) Fig. 7G, onto locking stud

(N) and insert locking stud (N) Fig. 7H, through slot in

fence slide. Thread locking stud into threaded hole in

fence slide support (E).

9. Position lock handle (M) Fig. 7J, on stud and

replace screw and spring (L) that were removed in

STEP 7. NOTE: Lock handle (M) is spring-loaded

and can be repositioned by lifting up on handle.

Fig. 7D

Fig. 7E

Fig. 7F

Fig. 7G

Fig. 7H

Fig. 7J

ATTACHING DUST BAG

Depress spring clips (A) Fig. 8, of dust bag (B) and clip

dust bag (B) over rib of dust chute.

Fig. 8

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 24 25

No comments

Delta 36-255L Instruction Manual Page 10