Delta 36-255L Instruction Manual download pdf (Page 15)

Fig. 24

Fig. 25

Fig. 26

Fig. 22

Fig. 23

ADJUSTING CHIP DEFLECTOR

1. DISCONNECT THE MACHINE FROM

THE POWER SOURCE.

2. A chip deflector (A) Fig. 22, is supplied to help

prevent scrap or cut-off pieces from entering the

upper blade guard. The chip deflector (A) should be

adjusted so that it is almost touching the side of the

blade. Loosen screw (B), adjust chip deflector (A)

and tighten screw (B).

ADJUSTING 0° AND 45° BEVEL POSITIVE

STOPS

1. DISCONNECT THE MACHINE FROM

THE POWER SOURCE.

2. Adjust saw so that both bevel and miter pointers are

set at 0°. Tighten bevel lock handle and lock

cuttinghead in down position.

3. Place one end of a square (A) Fig. 23 on the table and

the other end against the blade. The blade should be

set at 90° to the table.

4. If an adjustment is necessary, loosen bevel lock

handle (H) Fig. 24. Loosen locknut (B) and turn

adjusting screw (C), with wrenches provided, until

blade is 90° to the table. Tighten locknut (B) and

bevel lock handle (H).

5. When the blade is 90° to the table, adjust the pointer

to line up with the 0° mark on the bevel scale.

6. Loosen bevel lock handle (H) Fig. 24, and move

cuttinghead all the way to the left bevel position and

tighten bevel lock handle.

7. Use a square (A) Fig. 25, to see if the blade is at 45°

to the table.

8. If an adjustment is necessary, loosen the bevel lock

handle. Loosen the locknut (E) Fig. 26, and turn the

adjusting screw (F), with wrenches provided, until the

blade is 45° to the table. Tighten locknut (E) and

bevel lock handle.

9. These positive stops enable the operator to rapidly

position the blade at the most common bevel angles

to the table, 90° and 45°.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 24 25

Comments to this Manuals

No comments

Delta 36-255L Instruction Manual Page 15

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-255L