Delta 36-255L Instruction Manual download pdf (Page 18)

LEFT LASER

ADJUSTMENT

SCREW

Fig. H

Fig. G

Fig. F

TO CHECK FOR VERTICAL ALIGNMENT

1. The vertical alignment is set correctly when the lines

do not move horizontally (sideways) as the saw head

is raised and lowered. If vertical alignment is correct

jump to “TO SET LEFT AND RIGHT KERF

ADJUSTMENT”.

2. If the vertical alignment needs to be adjusted, begin

by backing the left and right kerf adjustment screws

one half turn clockwise. Remove the laser unit cover

by removing the phillips screw on either side of the

cover. (Fig. A).

3. Use the 1/8" hex wrench to turn the left or right

vertical alignment set screws. If as the saw head

goes from a raised to a lowered position and the

laser line moves horizontally away from the blade,

turn vertical alignment set screw clockwise to

correct. If the laser line moves horizontally towards

the blade, turn vertical alignment set screw counter-

clockwise to correct. (Fig. F)

4. Reinstall cover removed in step 1, and continue to

“TO SET LEFT AND RIGHT KERF ADJUSTMENT”.

TO SET LEFT and RIGHT KERF

ADJUSTMENT

1. Use the 1/8" hex wrench to turn the left or right kerf

adjustment screws and set the laser lines to either

side of the test cut (Fig. G). To adjust the left line turn

the left kerf adjustment screw counter-clockwise to

move the line toward the blade and clockwise to

move the line away from the blade. To adjust the

right line turn the right kerf adjustment screw

counter-clockwise to move the line toward the blade

and CW to move the line away from the blade. (Fig.

Observe laser CAUTION label (L)

Fig. H.

2. Remove the padlock and use normally.

TwinLaser

™

MAINTENANCE

For best laser performance, perform the following

maintenance regularly:

1. DISCONNECT THE MACHINE

FROM THE POWER SOURCE.

2. Carefully clean sawdust from each laser lens with a

cotton swab Fig. J. Do not use solvents of any kind

since they may damage the lens. Avoid touching

sharp points of saw blade with your hands or fingers.

Dust build-up can block the laser and prevent it from

accurately indicating the line of cut.

3. Remove blade from saw and clean pitch build-up

from blade Fig. K Pitch build-up can block the laser

and prevent it from accurately indicating the line of

cut.

Fig. J

LASER LENS

COTTON

SWAB

Fig. K

REMOVE BLADE

FOR CLEANING

RIGHT LASER

ADJUSTMENT

SCREW

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Delta 36-255L Instruction Manual Page 18

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-255L