Delta 36-255L Instruction Manual download pdf (Page 22)

Fig. 41

Fig. 42

Fig. 43

Fig. 45

Fig. 44

CHANGING THE BLADE

USE ONLY CROSS-CUTTING SAW

BLADES. DO NOT USE BLADES WITH DEEP

GULLETS AS THEY CAN DEFLECT AND CONTACT

GUARD

1. Use only 12" diameter blades with 1" arbor holes

that are rated for 4000 RPM or higher.

2. DISCONNECT THE MACHINE FROM

THE POWER SOURCE.

3. Loosen screw (A) Fig. 41, with wrench (B) (provided).

4. Rotate arbor cover (C) Fig. 42, and lower guard (D)

Fig. 42, to the rear, exposing arbor screw (E).

5. Remove arbor screw (E) Fig. 42, by turning screw

clockwise with wrench (supplied), while at the same

time, pressing in on arbor lock (F) Fig. 43, to keep the

arbor from turning. Remove outside blade flange (G)

Fig. 42, and saw blade (H) Fig. 41. DO NOT

REMOVE INSIDE BLADE FLANGE.

6. Attach the new saw blade MAKING CERTAIN

TEETH OF SAW BLADE ARE POINTING DOWN AT

THE FRONT, and attach outside blade flange (G)

Fig. 42. Check to see that the flats on outside blade

flange are engaged with flats on arbor shaft.

7. Thread arbor screw (E) Fig. 42, into saw arbor by

turning screw (E) counterclockwise as far as possible

by hand. Then tighten arbor screw (E) with wrench

supplied while at the same time pressing in on arbor

lock (F) Fig. 43, to keep arbor from turning.

8. Rotate arbor cover (C) Fig. 42, and lower guard (D) to

the front and tighten screw (A) Fig. 41 that was

loosened in STEP 3.

BRUSH INSPECTION AND

REPLACEMENT

BEFORE INSPECTING BRUSHES,

DISCONNECT THE MACHINE FROM THE POWER

SOURCE.

Brush life varies, depends on the load on the motor.

Check the brushes after the first 50 hours of use of a new

machine, or after a new set of brushes has been

installed.

After the first check, examine them after about 10 hours

of use, until replacement is necessary.

The brush holders (A) Fig. 44, are located on the motor

housing opposite each other. Fig. 45, illustrates one of

the brushes removed for inspection. When the carbon on

either brush (B) is worn to 3/16" in length, or if either

spring or shunt wire (C) is burned or damaged in any way,

replace both brushes. If the brushes are found

serviceable after removing, reinstall them in the same

position.

MAINTENANCE

TROUBLESHOOTING

For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call

the DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).

1 2 ... 17 18 19 20 21 22 23 24 25

Comments to this Manuals

No comments

Delta 36-255L Instruction Manual Page 22

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-255L