INSTRUCTION MANUALESPAÑOL: PÁGINA 17To learn more about DELTA MACHINERY visit our website at: www.deltamachinery.com.For Parts, Service, Warranty or o
DISCONNECT THE MACHINE FROM THE POWER SOURCE.1. Position the bevel detent plate so that the desired angle (A) Fig. 23 is exposed immediately to the le
11DISCONNECT THE MACHINE FROM THE POWER SOURCE.1. Position the bevel detent plate so that the desired angle (A) Fig. 25 is exposed.2. Lift the front h
If the size of the workpiece causes your hand to be inside the table hazard zone (see section “TABLE HAZARDZONE” SEE FIG. 21), use a clamp to secure t
13Fig. 36CORRECTCUTTING BOWED MATERIAL1. Check the workpiece. If it is bowed, position the workpiece on the table as shown in Fig. 36.2. When the work
14Fig. 42AMAINTENANCEDisconnect the machine from the power source.Fig. 43EGCDHFig. 44FCHANGING THE BLADEJ1. Use only 12" diameter blades (with 1&
15Fig.46BCFig. 45AABRUSH INSPECTION AND REPLACEMENTBefore inspecting brushes, disconnect the machine from the power source.Brush life varies, dependin
16Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine
The following are trademarks of PORTER-CABLE·DELTA (Las siguientes son marcas registradas de PORTER-CABLE S.A.): Auto-Set®,BAMMER®, B.O.S.S.®, Builder
2Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
3GENERAL SAFETY RULES1. FOR YOUR OWN SAFETY, READ THE INSTRUC-TION MANUAL BEFORE OPERATING THEMACHINE. Learning the machine’s application,limitations,
4ADDITIONAL SAFETY RULES FORMITER SAWSRefer to them oftenand use them to instruct others.FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.04
5Your new Compound Miter Saw is DOUBLE-INSULATED to give you added safety. As a result, this saw is equippedwith a two-prong plug which permits you to
6BFig. 3AAASSEMBLYAND OPERATION Fig. 3CDABFig. 4ATTACHING DUST BAG1. Attach dust spout (A) Fig. 3 to port (B).2. Depress spring clips (C) Fig. 3 of du
7Fig. 5ABCEDEFig.6FENCE OPERATIONThe saw is supplied with left fence segment (A) Fig. 7that incorporates a squeeze clamp feature. To operatethe fence
8ABCDEB1. The compound miter saw will cut any angle from a straight 0° cut to 48° right and left. Turn the locking knob (A) Fig. 13counterclockwise, d
9Fig. 16CADBDISCONNECT THE MACHINE FROM THEPOWER SOURCE.Fig. 15To adjust the sliding fit between the movable table and thebase, turn the nut (A) Fig.
Comments to this Manuals