Delta 36-312 Instruction Manual download pdf (Page 9)

Fig. 16

DISCONNECT THE MACHINE FROM THE

POWER SOURCE.

Fig. 15

To adjust the sliding fit between the movable table and the

base, turn the nut (A) Fig. 15 clockwise to tighten the fit

(counter-clockwise to loosen the fit). This adjustment

should not be so tight that it restricts the rotating movement

of the table, or so loose that it affects the accuracy of the

saw.

ADJUSTING SLIDING FIT BETWEEN MOVABLE TABLE AND BASE

ADJUSTING FENCE 90° TO BLADE

IMPORTANT: Before making this adjustment, set the

blade at 0° to the table. See section “Adjusting 0°,

33.9° and 45° bevel positive stops.”

DISCONNECT THE MACHINE FROM THE POWER SOURCE.

1. Place a framing square (E) Fig 16 on the table against the right fence (D). Rotate the movable table (A) Fig. 16 until

the blade (C) is 90° to the right fence.

2. Adjust the front miter scale (B) Fig. 16 so that 0° detent notch is engaged.

3. Adjust the miter curser (F) Fig. 17 so that the pointer is aligned with the 0° mark on the scale by loosening the screw

(G), adjusting the cursor (F), and tightening the screw (G).

4. Place one end of a framing square (A) Fig. 18 against the front of the right fence (B) and the other end against the

left fence base (C). Use the supplied wrench to loosen left fence base mounting screws (D) and adjust the left fence

base parallel to the right fence.

Fig. 18

Fig. 17

Fig. 21

TABLE HAZARD ZONE

The area inside the two red lines (A) Fig.

21 on the table is designated as a hazard zone. Never

place your hand(s) inside the "Table Hazard Zone"

(within the red lines) WHILE THE TOOL IS BEING

OPERATED. Clamp all workpieces which would

cause your hand(s) to be within the red lines.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta 36-312 Instruction Manual Page 9