Delta 36-953 Instruction Manual download pdf (Page 10)

Fig. 4

Fig. 5

Fig. 6

ASSEMBLING EXTENSION WING

NOTE: CHECK TO SEE WHAT TYPE OF STARTER

BOX WAS SHIPPED WITH YOUR SAW (GPE OR LVC).

A GPE STARTER HAS ROUND “ON” AND “OFF”

BUTTONS. A LVC STARTER HAS RECTANGLE “ON”

AND “OFF” BUTTONS.

NOTE FOR GPE ST

ARTER BOX: If your Unisaw was

shipped with an GPE starter box, the GPE “ON/OFF”

switch must be removed from the left side of the

Unisaw. When assembling the left extension wing, do

not install the front screw and washer at this time, it

will be installed when assembling the on/off switch.

NOTE FOR L

VC STARTER BOX: If your Unisaw was

shipped with an LVC starter box, the LVC “ON/OFF”

switch must be removed from the left side of the

Unisaw. Save the hardware that attached the LVC

“ON/OFF” switch to the Unisaw because it will be

used to re-attach the “ON/OFF” switch to the left

extension wing in the section “ASSEMBLING LVC

ON/OFF SWITCH.”

Assemble left extension wing (A) Fig. 5 to the saw table.

Align the three holes in the extension wing with the three

holes in the side of the saw table. Place a 7/16" flat

washer on a 7/16-20x1-1/4” hex head screw. Insert the

screw through the hole in the extension wing and thread

the screw into the tapped hole in the side of the table.

Repeat this process for the two remaining holes in the

extension wing and saw table. NOTE: TIGHTEN

SCREWS ENOUGH TO HOLD WING IN PLACE, BUT

LOOSE ENOUGH TO ALLOW THE WING TO BE

ADJUSTED FLUSH WITH THE TABLE.

With a straight edge (C) Fig. 6, make certain the

extension wing (A) is level with the saw table. Then,

tighten all three screws (B) Fig. 5 with an 18mm open

end wrench.

NOTE: MAKE SURE FRONT EDGE OF WING IS FLUSH

TO OR SLIGHTLY BEHIND THE FRONT EDGE OF THE

TABLE.

Place the right extension wing on the other side of the

saw in the same manner.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Delta 36-953 Instruction Manual Page 10

Comments to this Manuals

Related products and manuals for Mitre saws Delta 36-953