Delta 36-953 Instruction Manual download pdf (Page 11)

ASSEMBLING LVC STARTER BOX TO

CABINET

If you purchased the machine with magnetic push

button electrical controls, the saw is shipped with the

starter box completely wired to the switch and motor.

However, the starter box must be mounted to the saw

cabinet. To assemble the starter box (A) Fig. 7, to the

saw cabinet, proceed as follows:

1. Place a 1/4" lockwasher then a 1/4" flat washer onto

a 1/4-20x1/2" hex head screw. From the inside rear of

the saw cabinet, insert the 1/4-20 x 1/2" hex head screw

into the hole (B) Fig. 7, in the cabinet. Repeat this

process for the two remaining screws.

2. Line up the three tapped holes (C) Fig. 7, in the

starter box with the screws and secure the starter box

(A), to the saw cabinet.

3. Figure 8 illustrates the starter box (A) assembled to

the saw cabinet.

Fig. 7

Fig. 8

ASSEMBLING LVC ON/OFF SWITCH

1. Locate the LVC switch and hardware that was

removed in the section “ASSEMBLING EXTENSION

WING.”

2. Mount the switch bracket (C) Fig. 9, to the inside of

through hole D) on the left front edge of the extension

wing with the hardware that was removed.

NOTE: If you have a GPE switch see “ASSEMBLING

GPE ON/OFF Switch” instructions.

Fig. 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Delta 36-953 Instruction Manual Page 11