Delta 36-953 Instruction Manual download pdf (Page 15)

Fig. 28

Fig. 30

Fig. 29

ATTACHING MOTOR COVER

NOTE: IF YOU HAVE AN “LVC” (STARTER BOX)

VERSION UNISAW, YOU WILL HAVE TO ATTACH TWO

BOTTOM SPRING CLIPS TO THE MOTOR COVER. IF

YOU HAVE AN “GPE” (STARTER BOX) VERSION

UNISAW THE SPRING CLIPS ARE ALREADY

ATTACHED TO THE MOTOR COVER.

1. Attach the two motor cover clips to the motor cover.

Align the hole in the motor cover clip with the hole in the

motor cover. Place a 13/64 flat washer onto a 10-32x1/2"

screw (A), insert screw through the hole in the motor

cover clip and thread screw (A) into the tapped hole in the

motor cover, repeat this process for the remaining motor

cover clip, Fig. 32.

2. Place the motor cover (A) in the opening of the

Unisaw as shown in Fig. 33. Place the rear motor cover

clips inside the motor opening and push the front of the

motor cover until all 4 motor cover clips are engaged with

the motor cover opening in the Unisaw.

3. Fig. 36 shows the motor cover attached to the

Unisaw.

NOTE: TO REMOVE THE MOTOR COVER, PUSH

MOTOR COVER TO ONE SIDE TO DEPRESS CLIPS,

AND PULL MOTOR COVER OFF.

Fig. 32

Fig. 33

splitter (P) is aligned with the saw blade (B). Using a

square (C) Figs. 28 and 29, make certain saw blade (B)

Fig. 28, and splitter (P) Fig. 29, are 90 degrees to the table

surface. Once you are certain the splitter is aligned to the

saw blade and table, tighten all splitter mounting

hardware (D) Fig. 29 and recheck alignment.

13. Holding the clear blade guard, lower the saw blade

and assemble the table insert (E) Fig. 30, into the opening

on the saw table.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

No comments

Delta 36-953 Instruction Manual Page 15