Delta 36-953 Instruction Manual Page 19

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 18
19
ADJUSTING TABLE INSERT
Place a straight edge (B) across the table at both ends of
the table insert as shown in Fig. 46. The table insert (A)
should always be level with the table. If an adjustment is
necessary, turn the adjusting screws (C), as needed, with
allen wrench supplied. NOTE: THE MITER GAGE
HANDLE CAN BE USED TO STORE THE ALLEN
WRENCHES WHEN NOT IN USE. REMOVE THE TOP
CAP OF THE MITER GAGE HANDLE FOR THE ALLEN
WRENCH STORAGE COMPARTMENT.
Fig. 46
MITER GAGE OPERATION
AND ADJUSTMENT
Insert the miter gage bar into the miter gage slot and
assemble the washer and lock handle (A) Fig. 47, to the
miter gage bar as shown.
The miter gage is equipped with adjustable index stops at
90 degrees and 45 degrees right and left. Adjustment to
the index stops can be made by tightening or loosening
the three adjusting screws (B) Fig. 48, with allen wrench
supplied.
To rotate the miter gage, loosen lock knob (A) Fig. 48, flip
the stop link (D) down and out of the way, and move the
body of the miter gage (C), to the desired angle.
The miter gage body (C) can stop at 90 degrees and 45
degrees both right and left by flipping the stop link down
and out of the way and moving the miter gage body (C)
past the 90 and 45 degrees mark and flipping the stop
link (D) back up so that the stop link (D) will be able to
contact the adjusting screws (B) at the desired 90 or 45
degree angle. To rotate the miter gage body past these
points, the stop link (D) Fig. 48, must be down and out of
the way.
The head of the miter gage pivots on a special tapered
screw (G) that fastens the head to the miter gage bar. If
the miter gage head does not pivot freely, or pivots too
freely, it can be adjusted by loosening set screw (H) Fig.
49, and turning the screw (G) in or out. Be certain to
tighten screw (H) after adjustment is made.
Your miter gage is equipped with a plate (E) Fig. 49, which
fits into the T-Slot groove in the table. This allows the
miter gage to be pulled off the front edge of the table
without falling. This allows for a longer cut off capacity in
front of the blade.
Fig. 47
Fig. 48
Fig. 49
A
A
C
B
B
D
C
B
C
A
Page view 18
1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 31 32

Comments to this Manuals

No comments