www.deltamachinery.com(800) 223-7278 - US(800) 463-3582 - CANADA10" Contractors Saw(Model 36-978/36-979)Recolector de Polvo Portátil de Etapa Sen
108. Place the intake funnel assembly (A) on the lower support tube (B) Fig. 14. Secure it with a tube clamp (C).Fig. 14A C B ATTACHIN
1111Loosely thread the end of the dust bag strap (A) through the clamp (B) (Fig. 19). Place the open end of the dust bag (C) Fig. 19 over the outlet f
1212MACHINE USEThis versatile dust collector is light, compact. It can easily be transported for use in and out of the workshop. The dust collector ca
13Always disconnect the machine from the power source before performing any maintenance procedures.Check the condition of the dust bag periodically fo
14Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine
40The following are trademarks of PORTER-CABLE • DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marques suivantes son
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. When using tools or equipment, basi
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
1. FOR YOUR OWN SAFETY, READ THE INSTRUCTION MANUAL BEFORE OPERATING THE MACHINE. Learning the machine’s application, limitations, and specific hazar
ADDITIONAL SPECIFIC SAFETY RULES FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS INJURY.SAVE THESE INSTRUCTIONS.Refer to them oftenand use them to
6EXTENSION CORDSUse proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord which has a 3-prong grou
771. Dust collector2. Hose3. Dust bag4. Exhaust flange5. Exhaust flange gasket6. Intake funnel7. Intake support angle brace8. Upper support bracket9
88INSTALLING THE CASTERS 1. Place the dust collector on its side.2. Insert a caster through the four holes (A) Fig. 3 in the base of the dust collec
99INSTALLING THE DUST PORT TUBE AND THE DUST COLLECTOR CONNECTORDisconnect the machine from the power source!1. Place the tube clamp (A) Fig. 7 on th
Comments to this Manuals