Delta 36-R53 Instruction Manual download pdf (Page 13)

Fig. 29 Fig. 30

Fig. 32

13. Holding the clear blade guard, lower the saw blade

and assemble the table insert (E) Fig. 30, into the open-

ing on the saw table.

14. Place a straight edge (B) across the table at both

ends of the table insert as shown in Fig. 31.

THE TABLE INSERT (A) SHOULD

ALWAYS BE LEVEL WITH THE TABLE.

If an adjustment is necessary, turn the adjusting screws

(C), as needed, with the 1/8" allen wrench supplied.

FASTENING MOTOR CORD

TO SAW FRAME

1. IMPORTANT: Turn the blade tilting handwheel

counterclockwise as far as it will go until the saw blade is

in the 45 degree position.

2. IMPORTANT: Turn the blade raising and lowering

handwheel counterclockwise until the blade is at its

lowest position.

3. Fasten motor cord (A) Fig. 32 to the saw frame cross

member (B), using the cable tie (C) supplied with the saw.

CAUTION: Before tightening the cable tie, make certain

that cord (A) is free of any interference from the motor or

saw blade at all possible positions of the motor.

4. After the cable tie is tightened, cut off excess tail of

cable tie (C) Fig. 32.

Fig. 31

Fig. 33

MOTOR COVER

NOTE: IF YOU HAVE AN “LVC” (STARTER BOX)

VERSION UNISAW, YOU WILL HAVE TO ATTACH

TWO BOTTOM SPRING CLIPS TO THE MOTOR

COVER. IF YOU HAVE AN “GPE” (STARTER BOX)

VERSION UNISAW THE SPRING CLIPS ARE

ALREADY ATTACHED TO THE MOTOR COVER.

1. Attach the two motor cover clips to the motor cover.

Align the hole in the motor cover clip with the hole in the

motor cover. Place a 13/64 flat washer onto a 10-32x1/2"

screw (A), insert screw through the hole in the motor

cover clip and thread screw (A) into the tapped hole in the

motor cover, repeat this process for the remaining motor

cover clip, Fig. 33.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Delta 36-R53 Instruction Manual Page 13