Delta 36-R53 Instruction Manual download pdf (Page 23)

STORAGE

MITER GAGE HOLDER AND

WRENCH HOLDER

The miter gage and arbor wrenches can be stored in the

slots provided in the motor cover, as shown in Fig. 71.

Fig. 71

HEX WRENCH STORAGE

The miter gage handle can be used to store the two hex

wrenches (1/8", 5/64") supplied with the machine.

Remove the top cap (A) Fig. 72, of the miter gage handle

for the hex wrench storage compartment.

Fig. 72

MAINTENANCE

CHANGING THE SAW BLADE

DISCONNECT MACHINE FROM POWER

SOURCE.

1. NOTE: Two wrenches are supplied with the saw for

changing the saw blade; a box end wrench and open end

wrench.

2. Remove table insert and raise saw blade to its

maximum height.

3. Place the open end wrench (B) Fig. 73, on the flats of

the saw arbor to keep the arbor from turning, and using

box end wrench (A), turn the arbor nut (C)

counterclockwise. Remove arbor nut, blade flange and

saw blade.

4. Assemble the new blade, making certain the teeth are

pointing down at the front of the saw table and assemble

outside blade flange and arbor nut. With wrench (B) Fig.

73, on the flats of the arbor to keep it from turning, tighten

arbor nut by turning box end wrench (A) clockwise.

5. Replace table insert.

NOTE: Use only 10" saw blades with 5/8" arbor

holes, rated for at least 4000 RPM.

Fig. 73

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

No comments

Delta 36-R53 Instruction Manual Page 23