Delta 36-R53 Instruction Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 28
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
ASSEMBLY
FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE
INSTRUCTION MANUAL.
BLADE TILTING
HANDWHEEL
1. Install fiber washer (A) Fig. 3, on the blade tilting
handwheel shaft (B). Install key (C), into shaft keyway.
2. Place handwheel (D) on shaft (B) Fig. 3. Make sure
the groove (E), in the handwheel lines up with the key (C).
3. Push the handwheel snugly against the fiber washer
and tighten the set screw.
4. Install lock knob (F) Fig. 4, into threaded end of the
shaft (B). Hand-tighten lock knob at this time.
Fig. 3
Fig. 4
A
B
C
D
E
F
B
EXTENSION WINGS
NOTE: CHECK TO SEE WHAT TYPE OF STARTER
BOX WAS SHIPPED WITH YOUR SAW (GPE OR LVC).
A GPE STARTER HAS ROUND “ON” AND “OFF”
BUTTONS. A LVC STARTER HAS RECTANGLE “ON”
AND “OFF” BUTTONS.
NOTE FOR GPE STARTER BOX: If your Unisaw was
shipped with an GPE starter box, the GPE “ON/OFF”
switch must be removed from the left side of the
Unisaw. When assembling the left extension wing, do
not install the front screw and washer at this time, it
will be installed when assembling the on/off switch.
NOTE FOR LVC STARTER BOX: If your Unisaw was
shipped with an LVC starter box, the LVC “ON/OFF”
switch must be removed from the left side of the
Unisaw. Save the hardware that attached the LVC
“ON/OFF” switch to the Unisaw because it will be
used to re-attach the “ON/OFF” switch to the left
extension wing in the section “ASSEMBLING LVC
ON/OFF SWITCH.”
Assemble the extension wing (A) Fig. 5 , to the left side of
the saw table using the three 7/16"-20x1¼" hex head
screws (B) and 7/16" flat washers supplied. NOTE:
MAKE SURE FRONT EDGE OF WING IS FLUSH TO
OR SLIGHTLY BEHIND THE FRONT EDGE OF THE
TABLE. Use a straight edge (C) Fig. 6, to make sure the
extension wing (A) is level with the saw table before
tightening the screws (B) Fig. 5.
Assemble the right extension wing in the same manner.
Fig. 5
Fig. 6
B
A
C
A
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Comments to this Manuals

No comments