INSTRUCTION MANUALESPAÑOL: PÁGINA 21To learn more about DELTA MACHINERY visit our website at: www.deltamachinery.com.For Parts, Service, Warranty or o
10TABLE EXTENSION WINGSThis machine uses two table extension wings to help stabilize the machine, and to help support long or wideworkpieces. To attac
11OPERATIONSTARTING AND STOPPING THE MITER SAWTo start the miter saw, depress the switch trigger (A) Fig. 14. To stop the miter saw, release the switc
12BFig. 17Fig. 18CADDTILTING THE CUTTINGHEAD FOR BEVEL CUTTINGThe cuttinghead of your compound miter saw can betilted to cut any bevel angle from a 90
13Fig. 25HDADJUSTING THE 90° AND 45° BEVEL STOPSDISCONNECT THE MACHINE FROM THE POWER SOURCE.1. Lock the machine in the “down” position (Fig. 21).2. P
14HAZARD ZONEThe area inside the two red lines (A)Fig. 30 is designated as a “HAZARDZONE”. Never place your hands insidethis area while the machine is
15AUXILIARY WOOD FENCEWhen performing multiple or repetitiveoperations that result in small cut-off pieces(one inch or less), the saw blade can catcht
16GENERAL CUTTING OPERATIONSYour machine can cut:1. standard 2 x 4’s lying flat or on edge at 45° right andleft miter angles (Figs. 33 and 34).2. stan
17CUTTING CROWN MOULDINGOne of the many features of the saw is the ease of cutting crown moulding. The following is an example of cutting both inside
18181. Remove the screw (A) Fig. 44 and rotate the cover (B) to the rear (Fig. 45).2. Press in on the arbor lock (C) Fig. 46 to keep the arbor from tu
19BRUSH INSPECTION AND REPLACEMENTBrush life varies, depending on the load on the motor. Check the brushes after the first 50 hours of use for a newma
2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic
20A complete line of accessories is available from your Delta Supplier, Porter-Cable • Delta Factory Service Centers,and Delta Authorized Service Stat
The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE • DELTA S.A.) (Les marquessuivantes sont de
3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation
4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed
5FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY.1. DO NOT OPERATE THIS MACHINE UNTIL it isassembled and installed according to th
6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti
7EXTENSION CORDSUse proper extension cords. Make sureyour extension cord is in good condition and is a 3-wireextension cord which has a 3-prong ground
For your own safety, do not connect the machine to the power source until the machine iscompletely assembled and you read and understand the entire in
9FASTENING THE MACHINE TO THE SUPPORTING SURFACEBefore operating your compound miter saw, mount it toa sturdy workbench or other supporting surface. F
Comments to this Manuals