Delta PD-01 Specifications download pdf (Page 19)

PROFIBUS DP Slave Communicaion Module RTU-PD01

DVP-PLC Operation Manual

z Configuration method for 8AI, 4AI, 2AI and 1AI modules

Refer to the figure below for the relevant parameters to configure an 8AI module. 8AI, 4AI, 2AI and

1AI modules have the same parameters to set, except that the number of configurable CRs in 1AI, 2AI

and 4AI modules is different from that of 8AI module (Therefore, only the parameter settings for 8AI

are introduced in this section).

Definitions of configuration items:

Parameter Value Definition

Location 0 ~ 7

The location of the special I/O module at the right

side of RTU-PD01. The location of the first special

I/O module at the right side of RTU-PD01 is 0, the

second is 1 and so forth. This rule is only applicable

on special I/O modules.

Module

DVP04AD

DVP06AD

DVP02DA

DVP04DA

DVP06XA

DVP04PT

DVP04TC

DVP01PU

Special I/O module in use

Input CR number 1:

Slave → Master

0 ~ 48

Input CR number 2 0 ~ 48

Input CR number 3 0 ~ 48

Input CR number 4 0 ~ 48

Input CR number 5 0 ~ 48

Input CR number 6 0 ~ 48

Input CR number 7 0 ~ 48

Input CR number 8 0 ~ 48

No. of the CR in special I/O module to be read by

PROFIBUS DP master

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 43 44

No comments

Delta PD-01 Specifications Page 19