Delta PD-01 Specifications download pdf (Page 20)

PROFIBUS DP Slave Communicaion Module RTU-PD01

DVP-PLC Operation Manual

z Configuration method for 8AO, 4 AO, 2AO and 1AO modules

Refer to the figure below for the relevant parameters to configure an 8AI module. 8AO, 4AO, 2AO and

1AO modules have the same parameters to set, except that the number of configurable CRs in 1AO,

2AO and 4AO modules is different from that of 8AO module (Therefore, only the parameter settings

for 8AO are introduced in this section).

Definitions of configuration items:

Parameter Value Definition

Location 0 ~ 7

The location of the special I/O module at the right

side of RTU-PD01. The location of the first

special I/O module at the right side of RTU-PD01

is 0, the second is 1 and so forth. This rule is only

applicable on special I/O modules.

Module

DVP04AD

DVP06AD

DVP02DA

DVP04DA

DVP06XA

DVP04PT

DVP04TC

DVP01PU

Special I/O module in use

Output CR number 1:

Master → Slave

0 ~ 48

Output CR number 2 0 ~ 48

Output CR number 3 0 ~ 48

Output CR number 4 0 ~ 48

Output CR number 5 0 ~ 48

Output CR number 6 0 ~ 48

Output CR number 7 0 ~ 48

Output CR number 8 0 ~ 48

No. of the CR in special I/O module to be written

by PROFIBUS DP master

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 43 44

No comments

Delta PD-01 Specifications Page 20